Module SparkFun OpenLog

Module SparkFun OpenLog DEV-09530
Module SparkFun OpenLog
  • Rupture de stock
Module SparkFun OpenLog DEV-09530
Module SparkFun OpenLog
DEV-13
Rupture de stock
22,80 € TTC
19,00 € HT

Dont 0,01 € d'eco-participation déjà incluse dans le prix

Ce produit est épuisé. Nous maintenons sa présence sur notre site pour que les personnes ayant fait son acquisition puissent toujours avoir accès à sa documentation (mais ce dernier ne peut plus être commandé).

Reprise 1 pour 1         Frais de port à partir de 5.90 €   infos

 

Ce module est un data logger open source utilisable sur Arduino. Ce module est un data logger open source.

  • Log to low-cost microSD FAT16/32 cards up to 64GB
  • Simple command interface
  • Edit config.txt file from a computer to change baud rate and other system settings
  • Three modes:
    • NewLog creates a new log every power up and immediately starts logging
    • SeqLog appends a file called "SeqLog.txt" at every power up and immediately starts logging
    • Command mode starts OpenLog at a command prompt at power up
  • Configurable baud rates (2400 to 115200bps)
  • Configure unit through config file or the menu system
  • Power, ground, and RX-I are the minimum connections
  • Reprogrammable ATmega328 using the Arduino IDE
  • Two LEDs indicate writing status
  • Input voltage from 3.3V to 12V
  • 2mA idle, 6mA at maximum recording rate
  • 0.16 x 0.6 x 0.75" (4 x 15 x 19mm)
Aucun avis
Il est nécessaire d'être connecté pour laisser un avis
Produit ajouté à ma liste